|
|
| (19 intermediate revisions by 3 users not shown) |
| Line 1: |
Line 1: |
| − | = Taito Ice Cold Beer =
| + | {{WIP}} |
| | + | Here are a list of other pinball related, but not necessarily pinball games and their respective repair guides. |
| | | | |
| − | == Motor Replacement == | + | =Taito= |
| − | | + | *[[Taito_Ice_Cold_Beer|Taito's Ice Cold Beer]] |
| − | [[File:ICBOEMMotor.jpg|200px|thumb|left|The OEM Motor, showing the gear to be removed.]]
| |
| − | [[File:ICBReplacementMotorToInstall.jpg|200px|thumb|left|The replacement motor to be installed.]]<br>
| |
| − | [[File:ICBOEMMotorBracket.jpg|200px|thumb|left|The OEM bracket, showing 4 motor attach points.]]<br>
| |
| − | [[File:ICBHackMotorShaft.jpg|200px|thumb|left|Use a hack saw to cut the shaft of the original motor.]]<br>
| |
| − | [[File:ICBPunchGear.jpg|200px|thumb|left|Position the shaft/gear in a vice but don't tighten the vice on the shaft. Punch out the old shaft.]]<br>
| |
| − | [[File:ICBInstallGear.jpg|200px|thumb|left|With the "tail" of the new motor shaft on a solid surface, gently tap the original gear onto the new motor shaft.]]<br>
| |
| − | [[File:ICBNewGearInstalled.jpg|200px|thumb|left|The original gear, installed on the new motor shaft. Note that the shaft doesn't quite come to the gear edge.]]<br> | |
| − | [[File:ICBBracketMod.jpg|200px|thumb|left|Enlarge the hole in the original bracket to 13mm. Here a 1/2" drill bit is used to remove most of the material...]]<br>
| |
| − | [[File:ICBHoleEnlarge.jpg|200px|thumb|left|...and then a rat tail file is used to complete the enlargement.]]<br>
| |
| − | [[File:ICBModifiedBracketInstalled.jpg|200px|thumb|left|The original bracket, deburred, and installed on the new motor. Two screws are sufficient to hold the motor in place.]]<br>
| |
| − | [[File:ICBReplacementMotorGearInstalledView.jpg|200px|thumb|left|A view of the new motor and original gear, perfectly aligned with the motor gearbox.]]<br>
| |
| − | [[File:INewMotor.jpg|200px|thumb|left|The new motor, in place.]]<br>
| |
